2 in 1 Military soviet Russian gas mask Chemical Paint Spraying Full Face Facepiece Industry Respirator

Description:

• Before using the mask, its condition and tightness must be checked.

•Look around the front and make sure to expand the helmet visor as needed.

• Then confirm its integrity and highlight the eyewear components.

• Then check the valve box and valve status.

• Do not twist, break or block them.

• There should be no dents, rust, throat puncture-damage on the filter absorption box.

• Also drew attention to the fact that no cereal absorbent was poured into the packaging box.

• Respirators must be collected. Pick up the helmet mask of the valve box with your left hand.

• Right hand screw the entire filter absorption box navintovannoy neck of the outlet valve housing mask.

• Before wiping the inner and outer wipes with a clean cloth slightly moistened with water, use the new face of the mask, and then blow out the breathing valve.

• If you find the mask or other damage, remove them, if you cannot do this, replace the mask properly.

• The proven masks are assembled into bags: the downward filter absorption box is on the top-helmet mask, there are no folds, only a few lift up the head and sides to protect the glasses components.

Packaging:

Option 1: 1*gas mask

Option 2: 1 *mask + 1 *0.5m trachea

Option 3: 1 *mask + 1 *3 filter tank

Option 4: 2 *3 filter tank